
Fridges and freezers are a common source of mess on moving day. They leak, they smell, and a large one may not fit the stair you used when it was delivered. A little preparation avoids that.
The day before
Eat down or give away the food. Switch the appliance off in time for ice to melt. Catch the water. Wipe the inside dry, including door seals. Leave the doors slightly open until it is fully dry, then close them for the carry so they cannot swing.
Remove loose shelves if the maker says that is how the model travels, and pack them where they will not snap. Tape the lead to the back so it is not trapped under a wheel. Do not use the tape on a decorative front if it will mark the finish. A strap around the appliance is our job if we are moving it.
If the fridge has a water or ice line, arrange for that to be disconnected by someone qualified. We do not do plumbing or gas.
The carry
Tell us if it is a tall fridge-freezer or a wide American-style model. Measure the stair and the new kitchen door before the day if you can do so without moving the appliance yourself. In older Harrogate houses the turn on the landing is the usual problem.
We keep a fridge as upright as the route and the manufacturer allow. Do not lay it down to “make it fit” unless the booklet for that model says it is acceptable. Food should not travel inside it.
At the new house
Stand it in place, but do not fill it or switch it on until you have checked the instructions. Some models need to settle. That wait is in the booklet, not in a general rule we can invent.
The appliance can travel with a house removal or, if it is one of a few pieces, with furniture removals. Mention it when you get a free quote. We collect from Starbeck, Bilton and Harlow Hill as part of normal local work.
Planning a move in Harrogate?
Get a free, no-obligation quote, or try the cost calculator for a rough idea first.
Areas mentioned

